170 тыс. результатов.
Торренты на Нигма.РФ
  1. Visualizing the velocity on a boundary in CFX-Pre. Using the CFX Expression Language (CEL) to describe temperature dependent uid properties in CFX-Pre. ... This wall will be rotating, and therefore stationary relative to the rotating domain. ...
  2. ...and rotating frames of reference • Alternate rotation velocity advection model • Multiple frames of ... Burning velocity model (BVM) - Extended coherent flame model (ECFM), including wall quenching ... domains • Highly efficient parallel execution • Scalable memory usage Beta Features ANSYS® CFX... ...
  3. Firstly, I used rotating reference frame by assigning the control speed value omega to the "angular velocity" in the domain motion tab and zero velocity for wall velocity with no slip condition, so I can get relative velocity values from post-cfx. ...
  4. What is the difference between using a Rotating Domain and a Stationary Domain with rotating walls in CFX? ... If the flow is mainly rotating at a magnitude similar to the rotating wall velocity then the Rotating Domain is preferred. ...
  5. Once you have create the domain interface, you will see that CFX-Pre has automatically created some boundary conditions for the fluid and the solid side. You can then edit the fluid side boundary condition and set a wall velocity, or a counter rotating wall, or leave the walls as stationary as required. ...
  6. CFX-Pre enables you to specify a domain that is rotating about an axis. When you specify a Rotating Frame of Reference, you must also specify the angular velocity, ω ... Rotating Wall This option applies to both stationary and rotating domains and allows the wall to rotate with a specied angular velocity. ...
  7. For details on finite slip wall, see Finite Slip Wall in the CFX-Solver Modeling Guide. ... This option could be used to duplicate the counter rotating wall option in rotating frames by explicitly setting the angular velocity equal to minus one times the domain angular velocity. ...
  8. These domain wall velocities are well above literature values for single FeNi layers, for current densities that are at least a factor two smaller. Currently used spin-torque phenomenological models do not allow such large domain wall velocities to be explained... ...
  9. ...panel: Domain Motion – You can specify a domain that is rotating about an axis – When a domain with a rotating frame is specified, the CFX-Solver ... Roughness Parameters -Fixed Temperature (Heat Transfer) Heat Flux (Heat Transfer) -Heat Transfer Coefficient (Heat Transfer) Wall Velocity (for... ...
  10. Department of Mechanical Engineering University of Manitoba Page 11 of 25 ANSYS CFX Tutorial Laminar Flow in a Rectangular Duct 22 January 2013 V4.00 Boundary Details tab: Mass And Momentum: Option: select No Slip Wall Do not check the box by Wall Velocity Click OK The overall... ...
Страница:
предыдущая 1 2 3 4 5 6 ... следующая
 Ctrl
Ctrl 
В других поисковиках: Яндекс | Google | Rambler | Yahoo | AltaVista | Bing | Поиск@Mail.ru
Поиск реализован с использованием Яндекс.XML, Google, Rambler, Altavista, Sokr.ru и поисковой технологии Нигма.рф

Фильтр 

Вы не авторизованы